APRS Track Direct

My position About ☰

reset

QUAIL Telemetry

This is the latest recevied telemetry packets stored in our database for station/object QUAIL. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1732572921	137	33	76	41	48
1732572296	134	0	53	66	49
1732571668	141	28	122	41	48
1732571044	146	49	76	41	48
1732570414	145	39	75	41	48
1732569790	145	26	75	41	48
1732569170	144	1	60	41	44
1732568546	145	47	75	41	48
1732567925	145	45	77	41	48
1732567305	145	27	74	41	48
1732566687	145	24	74	41	48
1732566067	145	27	78	41	48
1732565443	146	27	77	41	48
1732564822	145	29	74	41	48
1732564193	145	28	78	92	49
1732563568	145	32	77	41	48
1732562945	145	60	75	41	48
1732562327	145	26	77	41	48
1732561703	146	28	114	41	48
1732561081	146	29	74	41	48
1732560463	145	30	126	41	48
1732559842	146	27	74	41	48
1732559222	147	7	95	42	62
1732558595	147	40	70	55	49
1732557972	148	45	78	41	48

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)