APRS Track Direct

My position About ☰

reset

LW6EQG-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object LW6EQG-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	RSSI*	Voltage*
1731261302	-48 dBm	9.23 V
1731259443	-45 dBm	9.23 V
1731257585	-46 dBm	9.25 V
1731255726	-48 dBm	9.23 V
1731253868	-50 dBm	9.27 V
1731252009	-48 dBm	9.25 V
1731250151	-48 dBm	9.23 V
1731248293	-51 dBm	9.29 V
1731246434	-53 dBm	9.25 V
1731244576	-52 dBm	9.27 V
1731242717	-56 dBm	9.27 V
1731240859	-55 dBm	9.25 V
1731239000	-55 dBm	9.23 V
1731237142	-56 dBm	9.25 V
1731235283	-56 dBm	9.25 V
1731233425	-56 dBm	9.25 V
1731231567	-56 dBm	9.25 V
1731229708	-53 dBm	9.25 V
1731227850	-56 dBm	9.27 V
1731225991	-57 dBm	9.27 V
1731224133	-56 dBm	9.27 V
1731222274	-56 dBm	9.27 V
1731220416	-57 dBm	9.27 V
1731218558	-57 dBm	9.27 V
1731216699	-56 dBm	9.23 V

*Used Equation Coefficients:

RxTraffic: 0, 1, 0

TxTraffic: 0, 1, 0

RxDrop: 0, 1, 0

RSSI: 0, -1, 0

Voltage: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)