APRS Track Direct

My position About ☰

reset

WB9TLH-12 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object WB9TLH-12. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	Rx1h*	Digi1h*	Eff1h*	Efftot*
1732267109	210 Pkt	130 Pkt	41 Pcnt	47 Pcnt
1732265308	190 Pkt	120 Pkt	39 Pcnt	47 Pcnt
1732263506	180 Pkt	120 Pkt	38 Pcnt	47 Pcnt
1732261704	190 Pkt	130 Pkt	42 Pcnt	47 Pcnt
1732259902	190 Pkt	130 Pkt	47 Pcnt	47 Pcnt
1732258101	180 Pkt	120 Pkt	49 Pcnt	47 Pcnt
1732256299	170 Pkt	120 Pkt	48 Pcnt	47 Pcnt
1732254497	180 Pkt	120 Pkt	46 Pcnt	47 Pcnt
1732252695	180 Pkt	110 Pkt	42 Pcnt	47 Pcnt
1732250893	170 Pkt	110 Pkt	44 Pcnt	47 Pcnt
1732249092	190 Pkt	130 Pkt	46 Pcnt	47 Pcnt
1732247290	200 Pkt	140 Pkt	47 Pcnt	47 Pcnt
1732245488	200 Pkt	140 Pkt	48 Pcnt	47 Pcnt
1732243686	200 Pkt	140 Pkt	51 Pcnt	47 Pcnt
1732241885	180 Pkt	130 Pkt	50 Pcnt	47 Pcnt

*Used Equation Coefficients:

Rx1h: 0, 10, 0

Digi1h: 0, 10, 0

Eff1h: 0, 1, 0

Efftot: 0, 1, 0

Volt: 0, 0.079, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)