APRS Track Direct

My position About ☰

reset

IU1VDW-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IU1VDW-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	IAQ*	CO2*	VOC*	GAS*
1786909182	64.71 idx	785.88 ppm	0.98 mg/m3	152958 ohm
1786907382	64.71 idx	785.88 ppm	1.08 mg/m3	139231 ohm
1786905582	103.93 idx	1654.11 ppm	8.33 mg/m3	127465 ohm
1786903782	109.82 idx	1847.05 ppm	11.37 mg/m3	129426 ohm
1786901982	117.66 idx	2039.99 ppm	19.21 mg/m3	127465 ohm
1786900182	145.11 idx	2715.28 ppm	24.99 mg/m3	109816 ohm
1786898382	158.84 idx	3101.16 ppm	24.99 mg/m3	103933 ohm
1786896582	156.88 idx	3101.16 ppm	24.99 mg/m3	107855 ohm
1786894782	178.45 idx	3776.45 ppm	24.99 mg/m3	92167 ohm
1786892982	184.33 idx	3969.39 ppm	24.99 mg/m3	94128 ohm
1786891182	200.02 idx	4355.27 ppm	24.99 mg/m3	84323 ohm
1786889382	200.02 idx	4451.74 ppm	24.99 mg/m3	82362 ohm
1786887582	215.71 idx	3679.98 ppm	24.99 mg/m3	76479 ohm

*Used Equation Coefficients:

IAQ: 0, 1.961, 0

CO2: 0, 96.47, 400

VOC: 0, 0.098, 0

GAS: 0, 1961, 0

n/a: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)