APRS Track Direct

My position About ☰

reset

E25WPV-13 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object E25WPV-13. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	RSSI*	VBAT*
1786755585	-47 dbm	11.68 V
1786755385	-46 dbm	11.69 V
1786755185	-46 dbm	11.69 V
1786754985	-47 dbm	11.63 V
1786754784	-46 dbm	11.67 V
1786754584	-46 dbm	11.5 V
1786754384	-46 dbm	11.64 V
1786754185	-45 dbm	11.62 V
1786753784	-46 dbm	11.72 V
1786753584	-46 dbm	11.74 V
1786753384	-46 dbm	11.63 V
1786753186	-46 dbm	11.7 V
1786752983	-49 dbm	11.68 V
1786752783	-45 dbm	11.69 V
1786752584	-46 dbm	11.68 V
1786752384	-48 dbm	11.66 V
1786751983	-46 dbm	11.74 V
1786751783	-46 dbm	11.69 V
1786751583	-45 dbm	11.7 V
1786751383	-47 dbm	11.64 V
1786751183	-50 dbm	11.68 V
1786750783	-47 dbm	11.75 V
1786750583	-46 dbm	11.79 V
1786750183	-46 dbm	11.63 V
1786749982	-47 dbm	11.66 V

*Used Equation Coefficients:

RSSI: 0, -1, 0

SUN: 0, 1, 0

VBAT: 0, 0.01, 0

LUX: 0, 0.01, 0

UVI: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)