APRS Track Direct

My position About ☰

reset

SP8SOB-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP8SOB-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1786723131	323 Count	360 Count	230 Count
1786722230	320 Count	357 Count	228 Count
1786721330	318 Count	355 Count	227 Count
1786720429	316 Count	354 Count	226 Count
1786719529	314 Count	352 Count	225 Count
1786718628	312 Count	350 Count	224 Count
1786717728	310 Count	349 Count	223 Count
1786716827	308 Count	347 Count	222 Count
1786715026	304 Count	343 Count	220 Count
1786714125	302 Count	341 Count	219 Count
1786713225	300 Count	339 Count	218 Count
1786712324	283 Count	322 Count	202 Count
1786711424	274 Count	313 Count	194 Count
1786710523	253 Count	292 Count	174 Count
1786709622	245 Count	284 Count	167 Count
1786708722	227 Count	266 Count	150 Count
1786707826	225 Count	264 Count	149 Count
1786706920	223 Count	262 Count	148 Count
1786705119	219 Count	259 Count	146 Count
1786704218	217 Count	257 Count	145 Count
1786703318	215 Count	256 Count	144 Count
1786702417	213 Count	255 Count	143 Count
1786701517	211 Count	253 Count	142 Count
1786700616	209 Count	251 Count	141 Count
1786699723	207 Count	249 Count	140 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)