APRS Track Direct

My position About ☰

reset

SV3GCB-13 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SV3GCB-13. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1786722852	110 Count	110 Count	62 Count
1786722247	108 Count	108 Count	61 Count
1786721642	106 Count	106 Count	60 Count
1786721038	104 Count	104 Count	59 Count
1786720433	102 Count	102 Count	58 Count
1786719828	100 Count	100 Count	57 Count
1786719223	98 Count	98 Count	56 Count
1786718619	96 Count	96 Count	55 Count
1786718014	94 Count	94 Count	54 Count
1786717409	92 Count	92 Count	53 Count
1786716804	90 Count	90 Count	52 Count
1786716200	88 Count	88 Count	51 Count
1786715595	86 Count	86 Count	50 Count
1786714990	84 Count	84 Count	49 Count
1786714386	82 Count	82 Count	48 Count
1786713781	80 Count	80 Count	47 Count
1786713176	78 Count	78 Count	46 Count
1786712571	73 Count	73 Count	42 Count
1786711967	71 Count	71 Count	41 Count
1786711361	69 Count	69 Count	40 Count
1786710756	67 Count	67 Count	39 Count
1786710151	65 Count	65 Count	38 Count
1786709547	63 Count	64 Count	37 Count
1786708941	61 Count	62 Count	36 Count
1786708336	59 Count	60 Count	35 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)