APRS Track Direct

My position About ☰

reset

UN1GWA-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object UN1GWA-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1754500063	345 Count	523 Count	188 Count
1754499157	342 Count	518 Count	186 Count
1754498252	339 Count	512 Count	184 Count
1754497346	336 Count	507 Count	182 Count
1754496441	333 Count	502 Count	180 Count
1754495535	330 Count	498 Count	178 Count
1754494630	327 Count	494 Count	176 Count
1754493724	324 Count	488 Count	174 Count
1754492819	321 Count	478 Count	172 Count
1754491914	318 Count	474 Count	170 Count
1754491008	315 Count	470 Count	168 Count
1754490103	312 Count	462 Count	166 Count
1754489330	309 Count	457 Count	164 Count
1754488424	306 Count	452 Count	162 Count
1754487519	303 Count	445 Count	160 Count
1754486614	300 Count	440 Count	158 Count
1754485708	298 Count	438 Count	157 Count
1754484803	297 Count	438 Count	157 Count
1754483897	296 Count	438 Count	157 Count
1754482991	295 Count	438 Count	157 Count
1754482086	294 Count	438 Count	157 Count
1754481180	293 Count	438 Count	157 Count
1754480274	292 Count	438 Count	157 Count
1754479369	291 Count	438 Count	157 Count
1754478463	290 Count	438 Count	157 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)