APRS Track Direct

My position About ☰

reset

HS3LSE-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object HS3LSE-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	RSSI*	Voltage*
1732299537	-55 dBm	0.18 V
1732296220	-47 dBm	0.06 V
1732294478	-49 dBm	0.06 V
1732291750	-54 dBm	0.18 V
1732289023	-54 dBm	0.21 V
1732286292	-61 dBm	0.18 V
1732283561	-51 dBm	0.08 V
1732280830	-50 dBm	0.06 V
1732278099	-47 dBm	0.06 V
1732277683	-49 dBm	0.21 V
1732274950	-47 dBm	0.06 V
1732272508	-52 dBm	0.04 V
1732269773	-52 dBm	0.21 V
1732267041	-54 dBm	0.18 V
1732264313	-53 dBm	0.21 V
1732261585	-54 dBm	0.18 V
1732258851	-54 dBm	0.21 V
1732257858	-52 dBm	0.21 V
1732255129	-55 dBm	0.21 V
1732252403	-49 dBm	0.21 V
1732250513	-51 dBm	0.21 V
1732247784	-51 dBm	0.21 V
1732245054	-49 dBm	0.06 V

*Used Equation Coefficients:

RxTraffic: 0, 1, 0

TxTraffic: 0, 1, 0

RxDrop: 0, 1, 0

RSSI: 0, -1, 0

Voltage: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)