APRS Track Direct

My position About ☰

reset

PY5AX-15 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object PY5AX-15. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1836274550	27	49	626	4	60
1778043461	25	77	118	4	58
1778041628	26	78	118	4	58
1778037044	26	76	117	3	57
1778026459	27	71	117	4	68
1778025541	27	72	117	4	69
1778024618	27	71	117	3	69
1778022786	28	71	117	3	69
1778020955	27	72	117	3	68
1778020041	27	72	117	4	69
1778018207	28	70	117	4	69
1778015457	27	69	117	4	69
1778014541	27	68	117	3	69
1778013626	27	68	117	4	69
1778012709	27	68	117	3	69
1778011793	27	68	117	4	69
1778009961	27	68	117	4	69
1778009044	27	68	117	3	69
1778008128	27	66	117	4	69
1778007211	28	67	117	3	69
1778006295	27	69	117	4	69
1778005379	27	71	117	3	69
1778004462	26	72	117	4	70
1778003546	26	72	117	3	70
1778002669	26	72	117	2	70

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)