APRS Track Direct

My position About ☰

reset

QUAIL Telemetry

This is the latest recevied telemetry packets stored in our database for station/object QUAIL. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1732450465	124	28	75	41	48
1732449847	124	26	86	41	66
1732449227	124	26	74	41	48
1732448609	125	25	75	41	48
1732447988	125	29	77	41	48
1732447368	125	27	76	41	48
1732446750	124	29	79	41	48
1732446127	124	44	74	41	48
1732445503	125	25	77	41	48
1732444883	125	27	81	41	48
1732444258	124	26	68	41	48
1732443633	125	23	75	41	48
1732443010	125	27	77	41	48
1732442387	125	27	79	41	48
1732441764	125	26	75	41	48
1732441146	126	28	131	42	48
1732440529	125	26	114	41	59
1732439909	126	27	77	41	48
1732439287	125	28	75	41	48
1732438665	125	40	88	41	48
1732438046	126	26	78	41	48
1732437423	125	29	68	41	48
1732436803	126	27	76	41	48
1732436181	126	26	77	41	48
1732435559	126	25	77	41	73

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)