APRS Track Direct

My position About ☰

reset

KC0SM Telemetry

This is the latest recevied telemetry packets stored in our database for station/object KC0SM. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	Value1*	Value2*	Value3*	Value4*
1744874599	100	48	2	128
1744873699	100	48	2	128
1744872739	100	48	2	128
1744871839	100	48	2	128
1744870879	100	48	2	128
1744869979	100	48	2	128
1744869019	100	48	2	128
1744868059	100	48	2	128
1744867099	100	48	2	128
1744866199	100	48	2	128
1744865239	100	48	2	128
1744864339	100	48	2	128
1744863379	100	48	2	128
1744862479	100	48	2	128
1744861519	100	48	2	128
1744860619	100	48	2	128
1744859719	100	48	2	128
1744858759	100	48	2	128
1744857799	100	48	2	128
1744856839	100	48	2	128
1744855939	100	48	2	128
1744854979	100	48	2	128
1744854079	100	48	2	128
1744853179	100	48	2	128

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)