APRS Track Direct

My position About ☰

reset

QUAIL Telemetry

This is the latest recevied telemetry packets stored in our database for station/object QUAIL. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1732269016	126	25	127	42	100
1732268397	125	28	77	41	48
1732267778	126	33	74	41	48
1732267151	125	36	74	41	48
1732266527	125	0	63	41	48
1732265910	125	29	74	41	48
1732265287	126	28	74	41	48
1732264661	126	26	74	41	48
1732264044	126	40	76	41	48
1732263420	126	31	76	41	48
1732262803	125	39	75	72	48
1732262184	126	25	74	41	48
1732261561	126	43	76	41	48
1732260941	126	27	80	41	49
1732259705	123	0	56	66	48
1732259081	124	0	46	66	48
1732258458	126	29	76	41	48
1732257215	126	27	75	41	48
1732256595	126	39	74	41	48
1732255978	126	28	81	41	51
1732255356	123	0	46	42	48
1732254736	126	27	76	41	48
1732254113	126	28	72	41	48
1732253489	127	26	75	41	48
1732252869	126	43	74	41	48

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)