APRS Track Direct

My position About ☰

reset

KQ6DI-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object KQ6DI-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1758210189	1204	789	386	779	50
1758209590	1204	790	386	784	50
1758208990	1201	791	386	784	50
1758208390	1202	791	386	784	49
1758207789	1207	791	392	784	50
1758207190	1204	792	386	784	49
1758206589	1204	792	392	784	48
1758206063	1201	792	386	784	49
1758143590	1199	814	397	806	56
1758142990	1198	812	397	806	57
1758142390	1199	808	402	797	55
1758141790	1198	805	392	797	56
1758141190	1198	803	392	797	57
1758140590	1204	799	386	792	57
1758139990	1198	797	386	788	56
1758139390	1198	794	386	788	57
1758138790	1198	791	392	784	57
1758137590	1198	786	381	779	57
1758136990	1198	782	386	774	57
1758136390	1198	780	381	770	56
1758135789	1199	778	376	770	57
1758135193	1198	776	376	770	98
1758134589	1198	773	381	766	57

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)