APRS Track Direct

My position About ☰

reset

IR3ZWX Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IR3ZWX. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1790648346	51	50	136	82	136
1790647744	51	50	136	82	136
1790647139	51	50	136	82	137
1790646535	51	50	136	82	137
1790645929	51	50	136	82	137
1790645327	51	50	136	82	137
1790644721	51	50	136	82	137
1790644119	51	50	136	82	138
1790643512	51	50	136	82	138
1790642911	51	50	136	82	138
1790642304	51	50	136	82	138
1790641702	51	50	136	82	138
1790640494	51	50	136	82	139
1790639887	51	50	136	82	139
1790639285	51	50	136	82	140
1790638679	51	50	136	82	140
1790638078	51	50	136	82	140
1790637471	51	50	136	82	141
1790636868	51	50	136	82	141
1790636263	51	50	136	82	141
1790635661	51	50	136	82	142
1790635054	51	50	136	82	142
1790634452	51	50	136	82	142
1790633846	51	50	136	82	143
1790633245	51	50	136	82	143

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)