APRS Track Direct

My position About ☰

reset

TA5LVC-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object TA5LVC-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	RSSI*	Voltage*
1790650224	-48 dBm	3.3 V
1790649324	-47 dBm	3.3 V
1790648424	-48 dBm	3.3 V
1790647524	-49 dBm	3.3 V
1790647496	-48 dBm	3.3 V
1790646596	-49 dBm	3.3 V
1790645696	-49 dBm	3.3 V
1790644796	-40 dBm	3.3 V
1790643896	-42 dBm	3.3 V
1790642996	-40 dBm	3.3 V
1790642096	-41 dBm	3.3 V
1790641196	-40 dBm	3.3 V
1790640296	-42 dBm	3.3 V
1790639396	-50 dBm	3.3 V
1790638496	-50 dBm	3.3 V
1790637596	-50 dBm	3.3 V
1790636696	-50 dBm	3.3 V
1790635796	-50 dBm	3.3 V
1790634896	-50 dBm	3.3 V
1790633996	-50 dBm	3.3 V
1790633091	-49 dBm	3.3 V
1790632191	-50 dBm	3.3 V
1790631291	-50 dBm	3.3 V
1790630391	-49 dBm	3.3 V
1790629491	-42 dBm	3.3 V

*Used Equation Coefficients:

RxPackets: 0, 1, 0

TxPackets: 0, 1, 0

RxDrop: 0, 1, 0

RSSI: 0, 1, -200

Voltage: 0, 0.1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)