APRS Track Direct

My position About ☰

reset

DJ1FC-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object DJ1FC-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*
1790653922	7 Count	39 Count
1790650314	5 Count	29 Count
1790646706	3 Count	19 Count
1790643098	1 Count	10 Count
1790639490	121 Count	1003 Count
1790635882	119 Count	992 Count
1790632274	117 Count	980 Count
1790628665	115 Count	969 Count
1790625057	113 Count	957 Count
1790621594	111 Count	946 Count
1790617986	109 Count	935 Count
1790614378	107 Count	929 Count
1790610770	105 Count	864 Count
1790607162	103 Count	859 Count
1790603554	101 Count	841 Count
1790599946	99 Count	792 Count
1790596337	97 Count	779 Count
1790592729	95 Count	766 Count
1790589121	93 Count	756 Count
1790585513	91 Count	747 Count
1790581905	89 Count	738 Count
1790578297	87 Count	724 Count
1790574689	85 Count	702 Count
1790571081	83 Count	685 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)