APRS Track Direct

My position About ☰

reset

YM2VTC-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object YM2VTC-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	RSSI*	Voltage*
1786724668	31 dBm	15.42 V
1786722181	31 dBm	13.68 V
1786721535	31 dBm	13.66 V
1786720909	31 dBm	13.64 V
1786719654	31 dBm	13.64 V
1786719028	31 dBm	13.64 V
1786717774	31 dBm	13.7 V
1786717148	31 dBm	13.56 V
1786716520	31 dBm	13.6 V
1786715894	31 dBm	13.62 V
1786714640	31 dBm	13.66 V
1786714013	31 dBm	13.56 V
1786713386	31 dBm	13.68 V
1786712759	31 dBm	13.68 V
1786711506	31 dBm	13.72 V
1786710252	31 dBm	13.66 V
1786708999	31 dBm	13.66 V
1786708373	31 dBm	13.23 V
1786707747	31 dBm	13.58 V
1786707119	31 dBm	13.7 V
1786706493	31 dBm	13.45 V
1786705241	31 dBm	13.9 V
1786704614	31 dBm	13.66 V
1786703359	31 dBm	13.68 V
1786702733	31 dBm	13.68 V

*Used Equation Coefficients:

RxTraffic: 0, 1, 0

TxTraffic: 0, 1, 0

RxDrop: 0, 1, 0

RSSI: 0, -1, 0

Voltage: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)