APRS Track Direct

My position About ☰

reset

ED5YAM Telemetry

This is the latest recevied telemetry packets stored in our database for station/object ED5YAM. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1732288163	509	578	999	37	515
1732287983	509	578	999	106	514
1732287803	509	578	999	55	517
1732287621	506	578	999	92	517
1732287439	511	578	999	36	520
1732287259	510	578	999	40	518
1732287078	511	578	999	29	516
1732286898	512	578	999	31	520
1732286717	512	578	999	62	519
1732286535	513	578	999	122	519
1732286356	513	578	999	77	526
1732286174	514	578	999	63	551
1732285994	513	578	999	71	533
1732285813	509	578	999	77	528
1732285633	513	578	999	31	523
1732285453	514	578	999	36	521
1732285272	515	578	999	95	530
1732285091	515	578	999	33	535
1732284911	514	578	999	37	520
1732284730	514	578	999	117	517
1732284549	515	578	999	81	521
1732284368	515	578	999	69	523
1732284187	516	578	999	21	522
1732284007	517	578	685	96	527
1732283827	518	578	999	80	532

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)