APRS Track Direct

My position About ☰

reset

HS4YSB-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object HS4YSB-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TxTraffic*	RSSI*	Voltage*
1732277971	1 Pkt	-54 dBm	0.04 V
1732275976	0 Pkt	-57 dBm	0.04 V
1732273986	0 Pkt	-54 dBm	0.04 V
1732272001	1 Pkt	-57 dBm	0.04 V
1732270010	0 Pkt	-56 dBm	0.04 V
1732268014	2 Pkt	-56 dBm	0.04 V
1732266024	4 Pkt	-56 dBm	0.04 V
1732264035	0 Pkt	-57 dBm	0.04 V
1732262044	0 Pkt	-57 dBm	0.04 V
1732260052	1 Pkt	-56 dBm	0.04 V
1732258074	0 Pkt	-56 dBm	0.04 V
1732256071	4 Pkt	-55 dBm	0.04 V
1732254082	1 Pkt	-57 dBm	0.04 V
1732252091	0 Pkt	-56 dBm	0.04 V
1732250102	0 Pkt	-56 dBm	0.04 V
1732248110	0 Pkt	-55 dBm	0.04 V
1732246119	0 Pkt	-56 dBm	0.04 V
1732244129	0 Pkt	-56 dBm	0.04 V
1732242139	0 Pkt	-57 dBm	0.04 V

*Used Equation Coefficients:

RxTraffic: 0, 1, 0

TxTraffic: 0, 1, 0

RxDrop: 0, 1, 0

RSSI: 0, -1, 0

Voltage: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)