APRS Track Direct

My position About ☰

reset

OE6XDG-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OE6XDG-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Volt*	Ampere*
1758242019	12.7 V	1198 A
1758240200	12.7 V	1189 A
1758238385	12.7 V	1189 A
1758236570	12.7 V	1189 A
1758234755	12.7 V	1205 A
1758232936	12.7 V	1195 A
1758231121	12.7 V	1188 A
1758229306	12.7 V	1191 A
1758227491	12.7 V	1188 A
1758225676	12.7 V	1194 A
1758223861	12.8 V	1188 A
1758222046	12.7 V	3715 A
1758220235	12.7 V	1843 A
1758218420	12.8 V	1264 A
1758216602	12.8 V	1184 A
1758214787	12.9 V	1185 A
1758212971	13.5 V	3864 A
1758211156	13.6 V	1168 A
1758209338	13.5 V	3715 A
1758207523	13.6 V	1161 A
1758205708	14.2 V	1319 A
1758203893	14.2 V	1145 A
1758202078	14.2 V	1146 A
1758200263	14 V	4241 A
1758199315	13.2 V	1285 A

*Used Equation Coefficients:

Volt: 0, 1, 0

Ampere: 0, 1, 0

Batt: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)