APRS Track Direct

My position About ☰

reset

OE1NHU-13 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OE1NHU-13. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1791748384	149	174	220	218	171
1791746575	149	174	220	218	148
1791743570	149	174	213	216	141
1791740564	149	174	214	230	168
1791738753	149	174	214	223	146
1791735746	150	175	223	241	142
1791732741	150	178	205	226	157
1791730932	150	179	213	227	140
1791727926	150	185	213	228	140
1791721913	150	184	217	231	157
1791720102	150	182	209	226	138
1791715286	150	178	206	228	140
1791712281	150	179	212	209	141
1791709275	149	181	214	211	142
1791704457	149	182	210	221	151
1791701452	148	187	221	220	146
1791698446	148	174	214	218	149
1791692435	148	171	217	227	147
1791689429	148	169	207	236	148
1791686423	149	171	209	220	145
1791684613	149	172	219	236	153
1791682803	149	172	212	228	142
1791680994	149	172	217	215	146
1791677988	149	173	219	235	152
1791674982	149	173	220	231	149

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)