APRS Track Direct

My position About ☰

reset

HS7ZSX-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object HS7ZSX-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	RSSI*	Voltage*
1786738686	-80 dBm	0.06 V
1786738376	-80 dBm	0.06 V
1786738066	-81 dBm	0.1 V
1786737756	-80 dBm	0.06 V
1786737446	-79 dBm	0.14 V
1786737136	-80 dBm	0.08 V
1786736826	-80 dBm	0.14 V
1786736516	-79 dBm	0.18 V
1786736206	-81 dBm	0.08 V
1786735896	-80 dBm	0.06 V
1786735586	-81 dBm	0.1 V
1786735276	-82 dBm	0 V
1786734966	-80 dBm	0.08 V
1786734656	-81 dBm	0.08 V
1786734346	-78 dBm	0.08 V
1786734036	-82 dBm	0.08 V
1786733726	-81 dBm	0.06 V
1786733416	-80 dBm	0.08 V
1786733106	-81 dBm	0.08 V
1786732796	-82 dBm	0.08 V
1786732486	-81 dBm	0.16 V
1786732176	-80 dBm	0.06 V
1786731866	-78 dBm	0.06 V
1786731556	-81 dBm	0.08 V
1786731246	-79 dBm	0 V

*Used Equation Coefficients:

RxTraffic: 0, 1, 0

TxTraffic: 0, 1, 0

RxDrop: 0, 1, 0

RSSI: 0, -1, 0

Voltage: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)