APRS Track Direct

My position About ☰

reset

KK4ODA-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object KK4ODA-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	Value1*	Value2*	Value3*	Value4*
1745002614	100	48	88	128
1745001714	100	48	93	128
1745000813	100	48	83	128
1744999913	100	48	88	128
1744999013	100	48	93	128
1744998113	100	48	93	128
1744997213	100	48	88	128
1744996313	100	48	88	128
1744995413	100	48	88	128
1744994512	100	48	93	128
1744993612	100	48	93	128
1744992712	100	48	83	128
1744991812	100	48	88	128
1744990911	100	48	88	128
1744990011	100	48	93	128
1744989111	100	48	88	128
1744988211	100	48	93	128
1744987311	100	48	93	128
1744986411	100	48	88	128
1744985511	100	48	95	128
1744984610	100	48	95	128
1744983710	100	48	93	128
1744982810	100	48	83	128
1744981910	100	48	83	128
1744981010	100	48	88	128

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)