APRS Track Direct

My position About ☰

reset

W7KKE-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object W7KKE-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value3*	Value4*	Value5*
1786786094	124	119	132
1786785195	123	119	132
1786784294	123	119	131
1786783395	123	119	132
1786782495	123	119	132
1786781595	124	119	132
1786780694	124	119	132
1786779795	124	120	132
1786778894	124	119	132
1786777995	124	119	132
1786777094	123	119	132
1786776196	125	120	132
1786775294	124	119	132
1786774395	124	119	132
1786773494	123	119	132
1786772595	124	119	132
1786771694	123	119	132
1786770795	123	119	132
1786769894	123	118	132
1786768094	123	119	132
1786767195	124	120	132
1786766294	123	119	132
1786764494	123	119	132
1786762694	123	117	133
1786760894	123	118	132

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)