APRS Track Direct

My position About ☰

reset

N9PBD-15 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object N9PBD-15. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	Vin*	Rx10m*	Dg1h*	Eff1h*	Temp*
1732287116	14.18 Volt	32 Pkt	110 Pkt	75 Pcnt	-64 C
1732283512	14.18 Volt	31 Pkt	90 Pkt	81 Pcnt	-64 C
1732279909	14.18 Volt	25 Pkt	70 Pkt	78 Pcnt	-64 C
1732276305	14.18 Volt	15 Pkt	50 Pkt	59 Pcnt	-64 C
1732272702	14.18 Volt	18 Pkt	50 Pkt	61 Pcnt	-64 C
1732269098	14.18 Volt	21 Pkt	60 Pkt	69 Pcnt	-64 C
1732265495	14.18 Volt	22 Pkt	60 Pkt	74 Pcnt	-64 C
1732261891	14.18 Volt	20 Pkt	60 Pkt	68 Pcnt	-64 C
1732258288	14.18 Volt	17 Pkt	60 Pkt	67 Pcnt	-64 C
1732254685	14.18 Volt	17 Pkt	60 Pkt	60 Pcnt	-64 C
1732251081	14.18 Volt	20 Pkt	70 Pkt	58 Pcnt	-64 C
1732247478	14.18 Volt	17 Pkt	70 Pkt	57 Pcnt	-64 C
1732243874	14.18 Volt	22 Pkt	90 Pkt	57 Pcnt	-64 C

*Used Equation Coefficients:

Vin: 0, 0.075, 0

Rx10m: 0, 1, 0

Dg1h: 0, 10, 0

Eff1h: 0, 1, 0

Temp: 0, 0.5, -64

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)