APRS Track Direct

My position About ☰

reset

KD6VEX-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object KD6VEX-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1732303803	23	27	27	22	19
1732302905	22	25	26	23	19
1732302003	22	28	26	22	18
1732301103	23	27	26	21	17
1732300203	23	27	26	21	19
1732299304	23	28	26	20	18
1732297504	23	26	26	22	19
1732296604	23	26	26	21	17
1732295704	21	27	25	22	19
1732294803	22	28	26	21	17
1732293004	22	28	27	22	17
1732292104	23	26	26	21	19
1732291204	23	28	27	22	19
1732290304	23	27	24	21	19
1732289404	23	27	26	20	19
1732288504	22	26	26	21	18
1732287604	23	27	26	20	18
1732286704	22	26	26	22	17
1732285804	22	27	26	22	19
1732284904	21	27	26	22	19
1732284004	21	27	25	22	18
1732283105	21	26	25	22	19
1732282204	23	27	26	22	18
1732281304	23	26	26	22	19
1732280404	22	28	27	22	20

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)