APRS Track Direct

My position About ☰

reset

OK0BAF-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OK0BAF-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1732292920	84	49	111	34	69
1732292021	93	61	113	34	69
1732291121	85	42	114	34	69
1732290222	86	54	114	34	67
1732289321	80	39	113	34	67
1732288420	93	55	112	34	67
1732287521	85	50	110	34	67
1732286621	91	61	110	34	67
1732285721	102	70	110	34	67
1732284821	103	72	110	33	67
1732283921	90	60	111	33	67
1732283021	89	55	111	33	67
1732282122	93	54	113	33	67
1732281221	100	60	110	33	67
1732280322	97	59	110	33	67
1732279421	92	61	110	33	67
1732278521	95	55	111	33	67
1732277621	84	60	114	33	67
1732276721	95	57	117	33	67
1732275821	87	54	111	33	67
1732274922	94	50	115	33	67
1732274021	87	53	111	33	67
1732273122	80	50	111	33	67
1732272221	77	54	111	33	67
1732271322	78	49	111	33	67

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)