APRS Track Direct

My position About ☰

reset

HS2LXA-12 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object HS2LXA-12. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	RSSI*	VBAT*
1786735851	-45 dbm	11.74 V
1786735651	-45 dbm	11.79 V
1786735451	-45 dbm	11.79 V
1786735250	-47 dbm	11.8 V
1786735050	-46 dbm	11.8 V
1786734851	-45 dbm	11.77 V
1786734651	-44 dbm	11.8 V
1786734250	-43 dbm	11.8 V
1786734050	-45 dbm	12.06 V
1786733850	-44 dbm	11.84 V
1786733650	-44 dbm	11.8 V
1786733450	-44 dbm	11.82 V
1786733250	-46 dbm	11.69 V
1786733050	-44 dbm	11.69 V
1786732850	-46 dbm	11.75 V
1786732449	-44 dbm	11.67 V
1786732249	-44 dbm	11.72 V
1786732049	-46 dbm	11.73 V
1786731849	-44 dbm	11.64 V
1786731649	-44 dbm	11.72 V
1786731449	-45 dbm	11.67 V
1786731249	-45 dbm	11.64 V
1786731049	-44 dbm	11.69 V
1786730649	-44 dbm	11.75 V
1786730448	-44 dbm	11.75 V

*Used Equation Coefficients:

RSSI: 0, -1, 0

SUN: 0, 1, 0

VBAT: 0, 0.01, 0

LUX: 0, 0.01, 0

UVI: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)