APRS Track Direct

My position About ☰

reset

YC4RWH-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object YC4RWH-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	RSSI*	Voltage*
1732275260	-38 dBm	19.97 V
1732274937	-40 dBm	20 V
1732274614	-37 dBm	19.97 V
1732274291	-39 dBm	20 V
1732273968	-37 dBm	20.04 V
1732273645	-40 dBm	20.14 V
1732273323	-38 dBm	20.26 V
1732273000	-39 dBm	4.94 V
1732272677	-38 dBm	5.41 V
1732272354	-37 dBm	5.95 V
1732272031	-38 dBm	7.92 V
1732271709	-40 dBm	8.94 V
1732271386	-39 dBm	9.8 V
1732271063	-37 dBm	10.58 V
1732270741	-38 dBm	10.97 V
1732270418	-38 dBm	11.48 V
1732270096	-38 dBm	12.41 V
1732269773	-38 dBm	12.65 V
1732269451	-38 dBm	12.63 V
1732269128	-36 dBm	12.8 V
1732268806	-39 dBm	13.78 V
1732268483	-41 dBm	13.99 V
1732268159	-40 dBm	14.19 V
1732267836	-36 dBm	15.05 V
1732267513	-38 dBm	15.3 V

*Used Equation Coefficients:

RxTraffic: 0, 1, 0

TxTraffic: 0, 1, 0

RxDrop: 0, 1, 0

RSSI: 0, -1, 0

Voltage: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)