APRS Track Direct

My position About ☰

reset

YO3JAZ-NC Telemetry

This is the latest recevied telemetry packets stored in our database for station/object YO3JAZ-NC. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1745003212	95	0	17	53	92
1745002852	95	0	17	55	93
1745002492	95	0	16	54	92
1745002132	95	0	20	53	93
1745001772	95	0	17	53	93
1745001412	95	0	17	52	92
1745001052	95	0	17	52	93
1745000692	94	0	17	55	92
1745000332	95	0	17	53	93
1744999972	95	0	17	56	93
1744999612	95	0	17	56	92
1744999252	95	0	17	53	93
1744998892	95	0	16	57	92
1744998532	95	0	17	56	92
1744998172	95	0	17	58	92
1744997812	95	0	16	58	93
1744997452	95	0	17	57	92
1744997092	96	0	250	57	93
1744996732	96	0	17	58	92
1744996372	97	16	17	58	93
1744996012	95	14	17	61	92
1744995652	95	16	17	58	92
1744995292	96	14	17	55	92
1744994932	96	14	17	57	93
1744994572	96	14	17	57	93

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)