APRS Track Direct

My position About ☰

reset

ZL1DTE-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object ZL1DTE-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1732299188	121	12	255	90	73
1732298887	121	12	255	90	73
1732298586	121	12	255	90	73
1732298285	121	12	255	90	73
1732297983	121	12	255	90	73
1732297682	121	12	255	90	73
1732297381	121	12	255	90	73
1732297080	121	12	255	90	73
1732296779	121	12	255	90	78
1732296478	121	12	255	90	78
1732296177	121	12	255	90	78
1732295876	121	12	255	89	78
1732295574	121	12	255	89	78
1732295273	121	12	255	89	78
1732294972	121	12	255	89	78
1732294671	121	12	255	89	78
1732294370	121	12	255	89	78
1732294069	121	12	255	89	78
1732293768	121	12	255	89	78
1732293467	121	12	255	89	78
1732293165	121	12	255	89	78
1732292864	121	12	255	89	78
1732292563	121	12	255	89	78
1732292262	121	12	255	89	78
1732291961	121	12	255	89	78

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)