APRS Track Direct

My position About ☰

reset

W8RIT Telemetry

This is the latest recevied telemetry packets stored in our database for station/object W8RIT. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1782490815	114	160	255	163	113
1782490515	114	160	255	164	114
1782490213	114	159	255	164	114
1782489912	114	159	255	164	114
1782489611	114	159	255	164	114
1782489310	114	159	255	164	114
1782489009	126	159	255	164	115
1782488706	127	159	255	164	115
1782488397	126	159	255	164	114
1782488093	126	159	255	164	115
1782487485	127	159	255	164	115
1782487177	130	159	255	164	115
1782486578	-	-	-	-	-
1782486569	126	158	255	165	116
1782486268	127	158	255	165	117
1782485967	127	157	255	166	118
1782485665	127	157	255	167	119
1782485359	126	156	255	168	121
1782485053	127	154	255	170	125
1782474514	127	156	255	167	119
1782473897	128	156	255	168	121
1782473288	125	155	255	169	123
1782472985	127	154	255	170	125
1782472374	129	151	255	174	131
1782420769	125	161	255	162	111

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)