APRS Track Direct

My position About ☰

reset

F1IXL-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F1IXL-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1782556073	134 Count	295 Count	123 Count
1782555470	129 Count	280 Count	119 Count
1782554867	116 Count	249 Count	107 Count
1782554270	103 Count	217 Count	95 Count
1782553661	99 Count	201 Count	92 Count
1782553056	89 Count	181 Count	83 Count
1782551856	75 Count	146 Count	71 Count
1782551246	63 Count	127 Count	60 Count
1782550643	46 Count	93 Count	44 Count
1782550039	35 Count	68 Count	34 Count
1782549436	19 Count	38 Count	19 Count
1782548832	516 Count	1025 Count	474 Count
1782548230	499 Count	996 Count	458 Count
1782547626	483 Count	962 Count	443 Count
1782547022	467 Count	928 Count	428 Count
1782546419	444 Count	882 Count	406 Count
1782545815	423 Count	842 Count	386 Count
1782545210	398 Count	801 Count	362 Count
1782544607	373 Count	767 Count	338 Count
1782544003	349 Count	724 Count	315 Count
1782543400	329 Count	680 Count	296 Count
1782542796	302 Count	640 Count	270 Count
1782542193	276 Count	596 Count	245 Count
1782540986	225 Count	516 Count	196 Count
1782540382	210 Count	476 Count	182 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)