APRS Track Direct

My position About ☰

reset

SP2OSA-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2OSA-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1749329298	215 Count	467 Count	58 Count
1749328397	214 Count	467 Count	58 Count
1749327496	213 Count	467 Count	58 Count
1749326595	212 Count	467 Count	58 Count
1749325694	211 Count	467 Count	58 Count
1749324793	210 Count	467 Count	58 Count
1749323892	209 Count	467 Count	58 Count
1749322990	208 Count	467 Count	58 Count
1749322090	207 Count	467 Count	58 Count
1749321188	206 Count	467 Count	58 Count
1749320288	205 Count	467 Count	58 Count
1749319387	204 Count	467 Count	58 Count
1749318486	203 Count	467 Count	58 Count
1749317585	202 Count	467 Count	58 Count
1749316684	201 Count	467 Count	58 Count
1749315783	200 Count	467 Count	58 Count
1749314882	199 Count	467 Count	58 Count
1749313980	198 Count	467 Count	58 Count
1749313101	197 Count	467 Count	58 Count
1749312200	196 Count	467 Count	58 Count
1749311299	195 Count	467 Count	58 Count
1749310391	194 Count	467 Count	58 Count
1749309490	193 Count	467 Count	58 Count
1749308589	192 Count	467 Count	58 Count
1749307688	191 Count	467 Count	58 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)