APRS Track Direct

My position About ☰

reset

FW0727 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object FW0727. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value4*	Value5*
1749329395	83	98	7	164
1749329044	83	98	7	164
1749328693	83	99	7	164
1749328333	83	99	6	164
1749327983	83	99	7	164
1749327634	83	100	6	164
1749327282	83	100	7	165
1749326922	83	100	6	164
1749326573	83	101	6	164
1749325860	83	101	6	165
1749325509	83	101	6	166
1749325159	83	102	6	164
1749324808	83	102	6	164
1749324458	83	102	6	165
1749324107	83	103	6	164
1749323747	84	103	6	165
1749323397	84	103	6	165
1749323047	84	104	6	165
1749322696	84	104	6	165
1749322336	84	104	6	165
1749321991	84	105	7	165
1749321631	83	105	8	166
1749321270	83	105	11	165
1749320921	83	106	20	166
1749320569	83	106	55	166

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)