APRS Track Direct

My position About ☰

reset

KC7HES-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object KC7HES-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1786730755	148 Count	26 Count	1 Count
1786728955	83 Count	20 Count	1 Count
1786727154	1037 Count	280 Count	15 Count
1786725354	931 Count	269 Count	13 Count
1786723553	799 Count	251 Count	12 Count
1786721753	671 Count	219 Count	10 Count
1786719956	528 Count	163 Count	7 Count
1786718156	385 Count	121 Count	5 Count
1786716356	258 Count	88 Count	4 Count
1786714555	102 Count	25 Count	2 Count
1786712755	1064 Count	385 Count	18 Count
1786710954	990 Count	360 Count	18 Count
1786709154	912 Count	326 Count	15 Count
1786707354	837 Count	289 Count	13 Count
1786705553	760 Count	251 Count	11 Count
1786703753	690 Count	235 Count	10 Count
1786701953	618 Count	211 Count	9 Count
1786700153	553 Count	179 Count	8 Count
1786698355	497 Count	163 Count	7 Count
1786696555	426 Count	140 Count	5 Count
1786694755	356 Count	121 Count	5 Count
1786692954	280 Count	97 Count	3 Count
1786691154	203 Count	67 Count	3 Count
1786689354	123 Count	22 Count	0 Count
1786687553	60 Count	10 Count	0 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)