APRS Track Direct

My position About ☰

reset

HS3LSE-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object HS3LSE-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	RSSI*	Voltage*
1732299359	31 dBm	1.03 V
1732297376	31 dBm	1.07 V
1732295398	31 dBm	1 V
1732293416	31 dBm	1 V
1732291433	31 dBm	1.03 V
1732289455	31 dBm	1.17 V
1732287473	31 dBm	0.94 V
1732285490	31 dBm	0.9 V
1732283512	31 dBm	0.88 V
1732281530	31 dBm	0.94 V
1732279547	31 dBm	0.86 V
1732277569	31 dBm	0.82 V
1732275587	31 dBm	0.98 V
1732273604	31 dBm	0.92 V
1732271626	31 dBm	0.86 V
1732269644	31 dBm	0.8 V
1732267661	31 dBm	0.66 V
1732265683	31 dBm	0.78 V
1732263701	31 dBm	0.74 V
1732261718	31 dBm	0.78 V
1732259741	31 dBm	0.66 V
1732257758	31 dBm	0.78 V
1732255775	31 dBm	0.82 V
1732253798	31 dBm	0.82 V
1732251815	31 dBm	0.78 V

*Used Equation Coefficients:

RxTraffic: 0, 1, 0

TxTraffic: 0, 1, 0

RxDrop: 0, 1, 0

RSSI: 0, -1, 0

Voltage: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)