APRS Track Direct

My position About ☰

reset

XE2OK-15 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object XE2OK-15. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1790633985	350 Count	494 Count	286 Count
1790633082	346 Count	488 Count	283 Count
1790632179	342 Count	480 Count	280 Count
1790631276	336 Count	472 Count	275 Count
1790630373	321 Count	448 Count	261 Count
1790629470	316 Count	438 Count	257 Count
1790628567	311 Count	431 Count	253 Count
1790627664	307 Count	423 Count	250 Count
1790626761	301 Count	414 Count	245 Count
1790625858	295 Count	405 Count	240 Count
1790624955	287 Count	394 Count	233 Count
1790624050	271 Count	376 Count	218 Count
1790623147	262 Count	362 Count	210 Count
1790622244	258 Count	356 Count	207 Count
1790621341	249 Count	345 Count	199 Count
1790620437	244 Count	337 Count	195 Count
1790619534	235 Count	324 Count	187 Count
1790618631	230 Count	313 Count	183 Count
1790617726	225 Count	305 Count	179 Count
1790616823	220 Count	297 Count	175 Count
1790615994	212 Count	292 Count	172 Count
1790615091	207 Count	284 Count	168 Count
1790614188	197 Count	271 Count	159 Count
1790613285	192 Count	262 Count	155 Count
1790612382	187 Count	256 Count	151 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)