APRS Track Direct

My position About ☰

reset

DG1MJG-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object DG1MJG-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1782494953	118 Count	658 Count
1782494353	117 Count	657 Count
1782493747	116 Count	655 Count
1782493144	115 Count	653 Count
1782492540	114 Count	642 Count
1782491931	113 Count	628 Count
1782491327	112 Count	624 Count
1782487235	111 Count	624 Count
1782486632	110 Count	616 Count
1782486029	109 Count	608 Count
1782485425	108 Count	599 Count
1782484822	107 Count	592 Count
1782484219	106 Count	586 Count
1782483616	105 Count	583 Count
1782483013	104 Count	573 Count
1782482409	103 Count	564 Count
1782481927	102 Count	552 Count
1782481323	101 Count	552 Count
1782480720	100 Count	543 Count
1782480117	99 Count	533 Count
1782478307	96 Count	515 Count
1782477703	95 Count	512 Count
1782477100	94 Count	511 Count
1782476497	93 Count	510 Count
1782475893	92 Count	509 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)