APRS Track Direct

My position About ☰

reset

KD2ABL Telemetry

This is the latest recevied telemetry packets stored in our database for station/object KD2ABL. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1732293603	134	81	255	168	127
1732292700	134	81	255	168	127
1732292400	134	80	255	169	127
1732292099	130	80	255	169	127
1732291799	127	80	255	169	127
1732291198	134	80	255	168	127
1732290897	132	80	255	169	127
1732289994	134	81	255	168	127
1732289689	128	81	255	168	127
1732289386	134	81	255	168	127
1732289086	132	81	255	168	127
1732288786	128	81	255	168	127
1732288485	133	81	255	168	127
1732288185	134	81	255	168	127
1732287884	133	82	255	168	127
1732287583	128	81	255	168	127
1732287282	129	82	255	168	127
1732286980	128	82	255	168	127
1732285778	134	82	255	168	127
1732285178	134	82	255	168	126
1732284877	128	82	255	168	126
1732284576	134	82	255	168	126
1732284276	130	82	255	168	127
1732283374	131	82	255	168	127
1732283074	130	81	255	168	127

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)