APRS Track Direct

My position About ☰

reset

BVILLE Telemetry

This is the latest recevied telemetry packets stored in our database for station/object BVILLE. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1732301413	143	39	128	42	69
1732300204	144	33	75	41	48
1732299602	143	74	77	41	48
1732299001	144	37	75	41	48
1732298400	142	39	75	41	48
1732297799	137	29	75	41	48
1732297199	142	37	76	66	49
1732296598	143	29	75	41	49
1732295997	149	38	76	41	48
1732295396	146	32	74	41	48
1732294795	144	35	76	66	49
1732294193	134	32	77	41	48
1732293592	132	33	75	68	49
1732292991	130	37	76	41	49
1732292391	130	36	127	42	48
1732291789	129	29	76	41	48
1732291189	129	33	76	65	49
1732290586	129	31	77	41	48
1732289986	129	35	113	42	98
1732289385	127	35	77	66	49
1732288783	127	33	75	41	49
1732288181	126	35	77	41	49
1732287581	126	39	78	41	49
1732286980	126	30	77	41	48
1732286380	126	47	114	42	60

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)