APRS Track Direct

My position About ☰

reset

SP2ROC-14 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2ROC-14. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1836274647	190 Count	677 Count	111 Count
1836274497	190 Count	677 Count	111 Count
1836274047	190 Count	677 Count	111 Count
1774087852	358 Count	890 Count	245 Count
1774087432	356 Count	883 Count	244 Count
1774087011	353 Count	873 Count	242 Count
1774086591	350 Count	865 Count	240 Count
1774086170	344 Count	852 Count	235 Count
1774085750	342 Count	846 Count	234 Count
1774085329	339 Count	837 Count	232 Count
1774084908	335 Count	826 Count	229 Count
1774084487	331 Count	816 Count	226 Count
1774084067	329 Count	812 Count	225 Count
1774083225	322 Count	795 Count	220 Count
1774082805	318 Count	786 Count	217 Count
1774082384	315 Count	777 Count	215 Count
1774081963	310 Count	765 Count	211 Count
1774081543	306 Count	756 Count	208 Count
1774081122	304 Count	750 Count	207 Count
1774080702	299 Count	739 Count	203 Count
1774080281	297 Count	733 Count	202 Count
1774079860	293 Count	724 Count	199 Count
1774079440	290 Count	716 Count	197 Count
1774079019	287 Count	708 Count	195 Count
1774078599	285 Count	701 Count	194 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)