APRS Track Direct

My position About ☰

reset

SQ3NVZ-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ3NVZ-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1791795306	155 Count	913 Count	100 Count
1791793505	148 Count	863 Count	97 Count
1791791704	143 Count	812 Count	93 Count
1791789903	140 Count	763 Count	91 Count
1791788101	132 Count	698 Count	88 Count
1791786299	127 Count	641 Count	85 Count
1791784498	119 Count	570 Count	82 Count
1791782697	112 Count	492 Count	80 Count
1791780895	107 Count	428 Count	76 Count
1791779093	101 Count	373 Count	73 Count
1791777292	96 Count	359 Count	69 Count
1791775491	93 Count	348 Count	67 Count
1791773690	89 Count	332 Count	64 Count
1791771888	86 Count	317 Count	62 Count
1791770087	81 Count	305 Count	58 Count
1791768286	78 Count	294 Count	56 Count
1791766485	74 Count	281 Count	53 Count
1791764714	71 Count	271 Count	51 Count
1791762913	67 Count	259 Count	48 Count
1791761112	63 Count	246 Count	45 Count
1791759311	58 Count	232 Count	41 Count
1791757510	51 Count	217 Count	39 Count
1791755708	47 Count	206 Count	36 Count
1791753907	44 Count	196 Count	34 Count
1791752106	40 Count	181 Count	31 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)