APRS Track Direct

My position About ☰

reset

TA1TAB-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object TA1TAB-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	RSSI*	Voltage*
1732290040	-66 dBm	13.39 V
1732289717	-69 dBm	13.39 V
1732289395	-67 dBm	13.41 V
1732289072	-70 dBm	13.39 V
1732288748	-68 dBm	13.47 V
1732288425	-68 dBm	13.45 V
1732288102	-67 dBm	13.47 V
1732287781	-68 dBm	13.47 V
1732287456	-69 dBm	13.47 V
1732287133	-68 dBm	13.47 V
1732286809	-68 dBm	13.47 V
1732286487	-68 dBm	13.47 V
1732286163	-68 dBm	13.47 V
1732285840	-69 dBm	13.47 V
1732285517	-68 dBm	13.47 V
1732285182	-69 dBm	13.47 V
1732284859	-67 dBm	13.47 V
1732284536	-69 dBm	13.45 V
1732284213	-69 dBm	13.47 V
1732283890	-69 dBm	13.47 V
1732283567	-69 dBm	13.47 V
1732283244	-70 dBm	13.45 V
1732282922	-67 dBm	13.47 V
1732282599	-70 dBm	13.47 V
1732282276	-69 dBm	13.47 V

*Used Equation Coefficients:

RxTraffic: 0, 1, 0

TxTraffic: 0, 1, 0

RxDrop: 0, 1, 0

RSSI: 0, -1, 0

Voltage: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)