APRS Track Direct

My position About ☰

reset

AJ6WO-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object AJ6WO-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1786739861	967 Count	3 Count	2 Count
1786739258	966 Count	3 Count	2 Count
1786738654	965 Count	3 Count	2 Count
1786738051	964 Count	3 Count	2 Count
1786737448	963 Count	3 Count	2 Count
1786736844	962 Count	3 Count	2 Count
1786736241	961 Count	3 Count	2 Count
1786735637	960 Count	3 Count	2 Count
1786735034	959 Count	3 Count	2 Count
1786734431	958 Count	3 Count	2 Count
1786733827	957 Count	3 Count	2 Count
1786733224	956 Count	3 Count	2 Count
1786732620	955 Count	3 Count	2 Count
1786732017	954 Count	3 Count	2 Count
1786731414	953 Count	3 Count	2 Count
1786730810	952 Count	3 Count	2 Count
1786730207	951 Count	3 Count	2 Count
1786729603	950 Count	3 Count	2 Count
1786728999	949 Count	3 Count	2 Count
1786728396	948 Count	3 Count	2 Count
1786727793	947 Count	3 Count	2 Count
1786727189	946 Count	3 Count	2 Count
1786726586	945 Count	3 Count	2 Count
1786725982	944 Count	3 Count	2 Count
1786725379	943 Count	3 Count	2 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)