APRS Track Direct

My position About ☰

reset

OK1JRA-16 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OK1JRA-16. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1745003478	2	2	49	42	53.33
1745002577	2	2	49	41	53.33
1745001676	2	2	49	40	53.33
1745000774	3	3	49	39	53.33
1744999874	2	2	49	38	53.33
1744998972	4	4	55	37	52.22
1744998071	0	0	0	36	53.33
1744997171	1	1	0	35	53.33
1744996270	1	1	0	34	26.67
1744995369	3	3	49	33	53.33
1744994467	1	1	54	32	53.33
1744993566	3	3	49	31	53.33
1744992665	1	1	0	30	53.33
1744991763	15	15	49	29	53.33
1744990862	17	17	26	28	53.33
1744989960	6	6	49	27	53.33
1744989059	3	3	49	26	53.33
1744988159	2	2	49	25	53.33
1744987258	0	0	0	24	28.33
1744986356	1	1	49	23	53.33
1744985456	3	3	49	22	28.33
1744984555	2	2	49	21	53.33
1744983654	1	1	49	20	53.33
1744982752	2	2	49	19	53.33
1744981851	1	1	0	18	53.33

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)