APRS Track Direct

My position About ☰

reset

SP5UID-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP5UID-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1836274168	19 Count	682 Count
1766281376	20 Count	640 Count
1766279575	19 Count	601 Count
1766277774	18 Count	569 Count
1766276582	17 Count	552 Count
1766274781	16 Count	529 Count
1766272979	15 Count	496 Count
1766271178	14 Count	455 Count
1766268783	13 Count	407 Count
1766266981	12 Count	400 Count
1766265180	11 Count	394 Count
1766263378	10 Count	371 Count
1766261578	9 Count	343 Count
1766259777	8 Count	307 Count
1766257976	7 Count	272 Count
1766256174	6 Count	233 Count
1766254374	5 Count	201 Count
1766252573	4 Count	157 Count
1766250771	3 Count	121 Count
1766248970	2 Count	90 Count
1766247800	1 Count	68 Count
1766245999	0 Count	32 Count
1766244198	17 Count	1015 Count
1766242396	16 Count	971 Count
1766239975	15 Count	919 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)