APRS Track Direct

My position About ☰

reset

KL3EX Telemetry

This is the latest recevied telemetry packets stored in our database for station/object KL3EX. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	Value1*	Value2*	Value3*	Value4*
1732306303	1156	116	89	25
1732305102	1156	115	89	25
1732303901	1153	116	89	21
1732302702	1156	115	89	19
1732301501	1156	115	89	17
1732300300	1158	115	89	16
1732299099	1156	116	89	16
1732297898	1158	116	89	16
1732296699	1156	116	89	16
1732295498	1156	116	89	16
1732294297	1156	116	89	16
1732293096	1156	115	89	18
1732291897	1156	116	89	16
1732290696	1158	116	89	16
1732289495	1158	116	89	16
1732288294	1156	116	89	16
1732287095	1158	116	89	16
1732285894	1156	116	88	17
1732284693	1158	115	88	16
1732283492	1158	115	88	15
1732282291	1156	115	88	15
1732281092	1158	114	87	16
1732279891	1156	114	88	16
1732278690	1156	114	88	15
1732277489	1156	114	88	15

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)