APRS Track Direct

My position About ☰

reset

OE4EXE-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OE4EXE-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1790663429	9 Count	316 Count
1790662825	8 Count	281 Count
1790662222	7 Count	229 Count
1790661618	6 Count	189 Count
1790661014	5 Count	163 Count
1790660411	4 Count	139 Count
1790659807	3 Count	104 Count
1790659203	2 Count	78 Count
1790658600	1 Count	50 Count
1790657996	0 Count	27 Count
1790657392	42 Count	1016 Count
1790656789	41 Count	996 Count
1790656185	40 Count	970 Count
1790655581	39 Count	944 Count
1790654978	38 Count	919 Count
1790654374	37 Count	891 Count
1790653770	36 Count	869 Count
1790653167	35 Count	846 Count
1790652563	34 Count	822 Count
1790651959	33 Count	793 Count
1790651355	32 Count	762 Count
1790650752	31 Count	743 Count
1790650148	30 Count	712 Count
1790649544	29 Count	682 Count
1790648941	28 Count	656 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)